Page:United States Statutes at Large Volume 121.djvu/1583

 121 STAT. 1562

‘‘(II) is not providing any standby or active mode function. ‘‘(iii) STANDBY MODE.—The term ‘standby mode’ means the condition in which an energy-using product— ‘‘(I) is connected to a main power source; and ‘‘(II) offers 1 or more of the following useroriented or protective functions: ‘‘(aa) To facilitate the activation or deactivation of other functions (including active mode) by remote switch (including remote control), internal sensor, or timer. ‘‘(bb) Continuous functions, including information or status displays (including clocks) or sensor-based functions. ‘‘(B) AMENDED DEFINITIONS.—The Secretary may, by rule, amend the definitions under subparagraph (A), taking into consideration the most current versions of Standards 62301 and 62087 of the International Electrotechnical Commission. ‘‘(2) TEST PROCEDURES.— ‘‘(A) IN GENERAL.—Test procedures for all covered products shall be amended pursuant to section 323 to include standby mode and off mode energy consumption, taking into consideration the most current versions of Standards 62301 and 62087 of the International Electrotechnical Commission, with such energy consumption integrated into the overall energy efficiency, energy consumption, or other energy descriptor for each covered product, unless the Secretary determines that— ‘‘(i) the current test procedures for a covered product already fully account for and incorporate the standby mode and off mode energy consumption of the covered product; or ‘‘(ii) such an integrated test procedure is technically infeasible for a particular covered product, in which case the Secretary shall prescribe a separate standby mode and off mode energy use test procedure for the covered product, if technically feasible. ‘‘(B) DEADLINES.—The test procedure amendments required by subparagraph (A) shall be prescribed in a final rule no later than the following dates: ‘‘(i) December 31, 2008, for battery chargers and external power supplies. ‘‘(ii) March 31, 2009, for clothes dryers, room air conditioners, and fluorescent lamp ballasts. ‘‘(iii) June 30, 2009, for residential clothes washers. ‘‘(iv) September 30, 2009, for residential furnaces and boilers. ‘‘(v) March 31, 2010, for residential water heaters, direct heating equipment, and pool heaters. ‘‘(vi) March 31, 2011, for residential dishwashers, ranges and ovens, microwave ovens, and dehumidifiers. ‘‘(C) PRIOR PRODUCT STANDARDS.—The test procedure amendments adopted pursuant to subparagraph (B) shall

dkrause on GSDDPC44 with PUBLAW

Regulations.

VerDate Aug 31 2005

07:12 Jan 26, 2009

PUBLIC LAW 110–140—DEC. 19, 2007

Jkt 059194

PO 00002

Frm 00270

Fmt 6580

Sfmt 6581

M:\STATUTES\2007\59194PT2.001

APPS10

PsN: 59194PT2

�