Page:United States Statutes at Large Volume 113 Part 1.djvu/143

 PUBLIC LAW 106-34-^JUNE 8, 1999 113 STAT. 119 "(A) meets the requirements of ISO/IEC Guide 25 (or another document approved by the Director under section 10(c)), including revisions from time-to-time; and "(B) has been accredited by a laboratoiy accreditation body that meets the requirements of ISO/IEC Guide 58 (or another document approved by the Director under section 10(d)), including revisions from time-to-time; "(2) 'consensus standard' means the provisions of a document that describes fastener characteristics published by a consensus standards organization or a Federal agency, and does not include a proprietary standard; "(3) 'consensus standards organization' means the American Society for Testing and Materials, the American National Standards Institute, the American Society of Mechanical Engineers, the Society of Automotive Engineers, the International Organization for Standardization, any other organization identified as a United States consensus standards organization or a foreign and international consensus standards organization in the Federal Register at 61 Fed. Reg. 50582-83 (September 26, 1996), and any successor organizations thereto; "(4) 'Director means the Director of the National Institute of Standards and Technology; "(5) 'distributor' means a person who purchases fasteners for the purpose of reselling them at wholesale to unaffiliated persons within the United States (an original equipment manufacturer and its dealers shall be considered affiliated persons for purposes of this Act); "(6) 'fastener' means a metallic screw, nut, bolt, or stud having internal or external threads, with a nominal diameter of 6 millimeters or greater, in the case of such items described in metric terms, or V* inch or greater, in the case of such items described in terms of the English system of measurement, or a load-indicating washer, that is through-hardened or represented as meeting a consensus standard that calls for through-hardening, and that is grade identification marked or represented as meeting a consensus standard that requires grade identification marking, except that such term does not include any screw, nut, bolt, stud, or load-indicating washer that is— "(A) part of an assembly; "(B) a part that is ordered for use as a spare, substitute, service, or replacement part, unless that part is in a package containing more than 75 of any such part at the time of sale, or a part that is contained in an assembly kit; "(C) produced and marked as ASTM A 307 Grade A, or a successor standard thereto; "(D) produced in accordance with ASTM F 432, or a successor standard thereto; "(E) specifically manufactured for use on an aircraft if the quality and suitability of those fasteners for that use has been approved— "(i) by the Federal Aviation Administration; or "(ii) by a foreign airworthiness authority as described in part 21.29, 21.500, 21.502, or 21.617 of title 14 of the Code of Federal Regulations; "(F) manufactured in accordance with a fastener quality assurance system; or

�