Page:United States Statutes at Large Volume 108 Part 2.djvu/323

 PUBLIC LAW 103-272—JULY 5, 1994 108 STAT. 1039 (B) transmissions of the same type produced at the same plant. (b) MANUFACTURER REQUIREMENT. — (1) Each manufacturer of a new passenger motor vehicle manufactured after September 30, 1994, and distributed in commerce for sale in the United States, shall establish each year for each model year and cause to be attached in a prominent place on each of those vehicles, at least one label. The label shall contain the following information: (A) the percentage (by value) of passenger motor vehicle equipment of United States/Canadian origin installed on vehicles in the carline to which that vehicle belongs, identified by the words "U.S./Canadian content". (B) the final assembly place for that vehicle by city. State " (where appropriate) and country. (C) if at least 15 percent (by value) of equipment installed on passenger motor vehicles in a carline originated in any country other than the United States and Canada, the names of at least the 2 countries in which the greatest amount (by value) of that equipment originated and the percentage (by value) of the equipment originating in each country. (D) the country of origin of the engine and the transmission for each vehicle. (2) At the beginning of each model year, each manufacturer shall establish the percentages required for each carline to be indicated on the label under this subsection. Those percentages are applicable to that carline for the entire model year. A manufacturer may round those percentages to the nearest 5 percent. (3) A manufacturer complying with the requirement of paragraph (1)(B) of this subsection satisfies the disclosure requirement of section 3(b) of the Automobile Information Disclosure Act (15 U.S.C. 1232(b)). (c) DEALER REQUIREMENT.—Each dealer engaged in the sale or distribution of a new passenger motor vehicle manufactured after September 30, 1994, shall cause to be maintained on that vehicle the label required to be attached to that vehicle under subsection (b) of this section. (d) FORM AND CONTENT OF LABEL.— The Secretary of Transpor- Regulations, tation shall prescribe by regulation the form and content of the label required under subsection (b) of this section and the manner and location in which the label is attached. The Secretary shall permit a manufacturer to comply with this section by allowing the manufacturer to disclose the information required under subsection (b)(1) on the Icibel required by section 3 of the Automobile Information Disclosure Act (15 U.S.C. 1232), on the label required by section 32908 of this title, or on a separate label that is readily visible. (e) REGULATIONS.— In consultation with the Secretaries of Commerce and the Treasury, the Secretary of Transportation shall prescribe regulations necessary to carry out this section, including regulations establishing a procedure to verify the label information required under subsection (b)(1) of this section. Those regulations shall provide the ultimate purchaser of a new passenger motor vehicle with the best and most understandable information possible about the foreign content and United States/Canadian origin of the equipment of the vehicles without imposing costly and unnecessary burdens on the manufacturers. The Secretary of Transportation shall prescribe the regulations promptly to provide adequate lead

�