Page:Treatise on poisons in relation to medical jurisprudence, physiology, and the practice of physic (IA treatiseonpoison00chriuoft).pdf/308

 Various processes for detecting corrosive sublimate in organic mixtures have been proposed by others. But none of these seem to me preferable to the method detailed above, with the exception of one which has been lately proposed by Professor Orfila, and which is particularly deserving of notice, because, although complex, he has found it sufficiently manageable and delicate for detecting mercury in the animal textures and secretions, into which it has obtained admission through the medium of absorption in cases of poisoning with the compounds of mercury. Like the previous process, however, it merely detects mercury, and cannot point out the state of combination in which mercury was administered, or mixed with the substance examined.

If the suspected matter be sufficiently liquid, boil for a few minutes and filter; acidulate the product with a few drops of hydrochloric acid; and immerse some slips of copper-leaf in it for a few hours. Should they be tarnished, dissolve oxide and chloride of copper from the surface by means of ammonia; wash them and press them between folds of filtering-paper; cut them in pieces, and heat these in a glass tube. Globules of mercury may be obtained or not. In either case, let the liquid, in which the plates were first immersed, be evaporated to dryness over the vapour-bath; add to the residue a sixth of sulphuric acid in a retort with a receiver; and heat gently till a nearly dry carbonaceous mass be obtained. Boil this with an ounce and a half of nitro-hydrochloric acid [Edin. Pharm.], until the charcoal be again nearly dry. Heat what remains with boiling distilled water, filter, apply to a small part of the liquid the copper test as just described, and try whether corrosive sublimate can be detached from the remainder by means of sulphuric ether (p. 299). The distilled fluid in the receiver may contain corrosive sublimate in considerable proportion, relatively to what existed in the subject of analysis. In order to discover it, boil the liquid for fifteen minutes with nitro-hydrochloric acid; transmit chlorine gas for an hour, filter, and evaporate to dryness over the vapour-bath; dissolve the residue in water, and search for corrosive sublimate both by copper plates, and by agitation with ether.

If mercury be not thus detected, proceed to the solid matter left on the filter, by which the subject of analysis was in the first instance separated into a liquid and solid part. Examine this by evaporation to dryness over the vapour-bath, and charring with sulphuric acid in a retort with a receiver attached; and then subject the product to the same steps as those detailed above for the dried residuum of the liquid part.

If the materials for analysis be soft solids, especially the stomach, intestines, liver, and the like, commence at once with the process of charring with sulphuric acid. In the case of the urine, examine both the liquid and sediment. Filter the liquid, transmit chlorine to excess, let the product rest twenty-four hours, filter, evaporate to dryness, dissolve the residue in water acidulated with hydrochloric acid, and test the solution both with copper-leaf and by agitation with ether. Heat the sediment with nitro-hydrochloric acid as