Page:The Bell System Technical Journal, Volume 1, 1922.pdf/8

8 that occur along the faces, while the glass wrapping round the edges of the ribbon is called upon to withstand much greater tensile stresses and gives way. If the edges of the ribbon are sharpened as shown in Fig., a tight seal results, the reason being that the forces of adhesion between the glass and copper acting along the flat contact faces are sufficient to stretch the thin copper at the edge and prevent its drawing away when cooled. There is definite relation between the elastic properties of the metal and glass and the angle of edge that can be used for a successful seal.



By proper shaping of the metal ribbon, seals have been successfully made up to very large sizes. Some of these are shown in Fig. 3, the thethe [sic] largest in the photograph being about 1″ in width, and capable of successfully conducting a current of 150 to 200 amperes.

The principles involved in the making of the disc seal are the same as those involved in making the ribbon seal. If a metal disc is sealed wholly into glass the edges must be sharpened or the glass and copper break away from each other as in the case of the ribbon seal.

In the general use to which these seals are put there is no necessity for having the glass surround the circumference of the copper disc