Page:Shaving Made Easy 1905.djvu/35

 the surface of the hone as smooth as possible.

Before commencing the operation, wipe the hone clean, then put on a few drops of oil or else cover it with water or lather. This will float the little particles of steel ground off the razor, thus preventing them from remaining directly on the hone to impede its full and equal effect. With most hones you may use either water, lather or oil; but do not change from one to the other; whichever you begin with, use that exclusively. It requiesrequires [sic] a longer time to produce a keen edge when oil is used but the edge is somewhat smoother. Most barbers use lather and we should advise the beginner to do so.

The hone, with its fine surface up, should be placed perfectly flat on a table or other solid foundation. (The rough surface is intended merely as a support and not for use.) After covering the