Page:Newdressmakerwit00butt.djvu/45

Rh waist. If it is a fitted lining extending below the waistline and not attached to another edge, it may be finished according to the instructions for finishing the neck and armhole edges of silk or cotton linings on the preceding page. Or the edge may be simply bound with seam-binding.

THE OUTSIDE WAIST should be put together according to the Deltor or Illustrated Instructions with the pattern.

If any alterations were made in the lining the same alterations should be made in the outside waist. Try the waist on to be sure that it fits properly.

FINISHING THE OUTSIDE WAIST. The finish depends on the material and the design of the pattern. The seams are finished differently for silk, wool and cotton. (Chapter 17.)

The underarm seams of a kimono waist made of a non-transparent material should be clipped to prevent their drawing at the curve. They are then finely overcast or bound with seam-binding. If the material is transparent, cut away the seam to one-quarter of an inch width and overcast it finely, or have the seam machine hemstitched. (Chapter 25.)

Piecing in a kimono sleeve where the material is transparent should be machine hem-stitched. (Chapter 25.) In any other material it may be piped. (Chapter 26.) In silks or satins the piecing seam may be machine hemstitched or fagoted. (Chapter 25.)

THE COLLAR. Removable and attached collars for the open neck and the high collar are given in Chapter 23, page 110.

FINISHING A COLLARLESS NECK. In sheer materials the edge of a collarless neck may be picoted (Chapter 25, page 1 19) or bound with a bias binding (Chapter 26, page 131).

In silk, satin, heavier cotton materials and linen the neck edge may be bound.

In wool materials the neck edge may be bound with a lighter weight material like satin, or with braid.

In any material which is not sheer the neck edge may be picoted.

A soft finish is much used on silk and wool materials and on velvet. For this soft finish turn under the seam allowance on the neck edge and cover it with seam-binding sewed on flat like a facing. No sewing should show on the outside. In silk and wool materials if there are seams or closing edges or embroidery or trimming of any sort, the inner edge of the seam binding may be tacked to the seam, closing edge, etc. In any other case it should be left free and simply lie flat against the edge. Press the neck edge and since there is no strain on it the seam-binding will he flat against the neck and stay in place. In velvet the inner edge of the seam-binding may be blind-stitched, for this can easily be done in invisibly on this material. In heavier cotton and linen materials use seam-binding as a facing. The inner edge must be hemmed invisibly or stitched in place on wash materials.

THE SLEEVES are considered by some people as the most difficult part of a costume. Great caution is necessary to keep them exactly alike, from the time the sleeves are cut until they are finished and sewed in the armhole. If not correctly cut and basted, one sleeve may be larger than the other. If they are not stitched in the armhole exactly alike, one may twist while the other hangs without a wrinkle. The finish of the bottom of a dress sleeve is handled in Chapter 23, page 111.

In sewing in a set-in sleeve hold the sleeve toward you when basting it or sewing it by hand, for it is easier to control the ease or fulness in this position.

THE ARMHOLE. Do not bind the armhole. After the sleeve has been sewed in, overcast the armhole seam unless the material is transparent and is to be machine hemstitched. In sheer material which is not hemstitched the armhole seam should be cut to about one-quarter of an inch width before overcasting it.

THE FINISH OF THE WAISTLINE OF THE OUTSIDE WAIST is a matter of style. Follow the information given with the pattern. The waist may be made separately or joined to the skirt. In both cases instructions for finishing it are given with the pattern.