Page:Newdressmakerwit00butt.djvu/44

40 on the inside of the lining with a fold at the line that marks the closing. Turn over both thicknesses and baste them very carefully. Then stitch with one row of stiching ⅛ of an inch from the edge and another ⅜ of an inch inside of that. (Ill. 71.)

Where no hem is allowed at the closing edge of the lining it is necessary to face it. Cut two pieces of the lining material the same outline as the front or back where the opening comes, and about two inches wide. Baste one on the outside of each front or back with their right sides together. Stitch the seams and turn the facing over toward the inside. Stitch it just as you would a hemmed edge.

Hooks and eyes are then sewed on. (Chapter 24, page 116.) Sew the hooks and eyes right through the lining allowing the stitches to go through to the right side so as to make the sewing strong and durable. Be careful in sewing on the hooks and eyes on the second side to have them exactly correspond in position to those of the opposite side.

INSIDE BELT. An inside belt is sometimes used in fitted linings. Get the regular silk or cotton belting for this purpose and make it three inches longer than your waist measure. Turn back an inch and a half at each end, sew on a hook on one edge and the eye on the other (Ill. 72), and hem the raw edges over their ends. (Ill. 72.) Mark the center of the belt and sew it to the center front seam if the lining opens at the back. If it opens in the front, sew it to the center back of the lining with the lower edge of the belt half an inch above the normal waistline. (Ill. 73.) Sew across the width of the belt with a long cross-stitch to the inside of the seam.

FINISHING THE NECK AND ARMHOLE EDGES OF THE LINING depends on the lining material and on the waist material. In silk or cotton linings turn the edges under; clip them whenever necessary to make them lie flat. In the silk lining finish them with ribbon seam-binding sewed on flat like a facing. In a cotton lining use lawn binding in the same way.

Narrow lace may be whipped to the edges. (Ill. 70.) This is always done in a French dress or any good dress.

If the lining is of net or Georgette, narrow lace may trim the neck and armholes. (Ill. 70) Apply the lace as explained in Illustration 311, page 134, or the edges may be finished with a narrow bias facing (Chapter 19, page 94) of the lining material and narrow lace whipped to the edge, or the neck and armhole edges may be picoted. (Chapter 25, page 119.)

THE TOP OF A CAMISOLE LINING used under transparent materials may be finished with a facing of the lining material. Or an allowance may be made for a hem if the pattern has none and the hem used to form a casing. The lower edge of the facing or hem may be machine hemstitched. One or two additional rows of hemstitching may be put below as a trimming. Lace may be whipped to the top if desired. (Ill. (69.) Work a buttonhole in the lining at each side of the center, run a ribbon through the casing (Ill. 69) and tie the ribbon in a bow.

A wide band of lace may be used to trim the top. (Chapter 27, page 134.)

Or the top of the camisole lining may be turned to the outside and covered with lace beading. Ribbon is run through the beading and tied in a bow.

The shoulder-straps of a camisole lining may be of ribbon or lace. (Ill. 69.)

The finish of the lower edge of the lining depends on the design of the pattern of the