Page:NIOSH Manual of Analytical Methods - Chapter D.pdf/10

 Field blanks are clean samplers taken to the sampling site, handled in every way as the air samples, except that no air is drawn through them. Media blanks are simply unopened, new samplers which are sent with the samples (these blanks are not usually taken to the field). It is also recommended that additional blind field blanks be sent along with the field samples, labeled as field samples, as a further check on the analysis. Blanks are good insurance to deal with contamination, but the best approach is to avoid sample contamination by being careful. The recommended practice for the number of field blanks is two field blanks for each 10 samples with a maximum of 10 field blanks for each sample set. Media blanks should also be included. These unexposed, unopened samplers will give an estimate of media background. The laboratory should analyze at least six (6) media blanks from the same lot as the field samples. This number should be increased for media which are coated or impregnated with reagent. Again, consult the specific method for the number and type of blanks as these numbers will vary.

Another frequently-used practice is to include blind spiked samples as a quality control check of the analytical laboratory. See the following chapter for a detailed discussion of spiking procedures.

5. DIRECT-READING METHODS

The variety of types of direct-reading methods available is large and expanding, including detector tubes (both short- and long-term), aerosol monitors, integrating passive monitors for certain gases and portable instrumentation for gas chromatography or infrared spectroscopy [13]. Many direct-reading instruments now used for personal or area measurements have evolved from laboratory or process control instruments [14].

Some of the considerations (i.e., specificity and sensitivity) for the use of direct-reading methods for quantitative determinations are similar to those already given for classical filter or sorbent methods. In many cases, direct-reading instruments, which are physically small and portable, qualify as personal sampling devices.* These offer the additional advantages over classical methods by reducing labor and analytical costs and may be the methods of choice when instantaneous results are important, even at the expense of some degree of sensitivity or specificity. In general, manufacturers' instructions should be followed in the calibration and use of these devices. Because of the severe conditions to which direct-reading instruments may be subjected, performance checks and preventive maintenance on a periodic basis or before each use are very important. Many direct-reading instruments are powered by Ni-Cd batteries which can fail to provide a full charge over the full sampling period unless frequently or fully discharged and recharged several times just prior to use. An additional responsibility, that of field calibration of the direct-reading instrument, falls on the field sampling personnel.

* NOTE: A portable instrument is defined as weighing less than 4.5 kg (10 lbs.) and powered by self-contained batteries [15]. For personal monitoring, the instrument configuration should be such that the breathing zone can be monitored. Alarms, both audible and visual, and hard-copy documentation are desirable. 1/15/98