Page:NIOSH Manual of Analytical Methods - 1613.pdf/3

 PYRIDINE: METHOD 1613, Issue 2, dated 15 August 1994 - Page 3 of 4 9.

10.

Determine desorption efficiency (DE) at least once for each batch of charcoal used for sampling in the calibration range (step 8). Prepare three tubes at each of five levels plus three media blanks. a. Remove and discard back sorbent section of a media blank sampler. b. Inject a known amount (2 to 20 µL) of DE stock solution, or a serial dilution thereof, directly onto front sorbent section with a microliter syringe. c. Cap the tube. Allow to stand overnight. d. Desorb (steps 5 through 7) and analyze together with working standards (steps 11 and 12). e. Prepare a graph of DE vs. mg pyridine recovered. Analyze three quality control blind spikes and three analyst spikes to ensure that the calibration graph and DE graph are in control.

MEASUREMENT: 11.

12.

Set gas chromatograph according to manufacturer's recommendations and to conditions given on page 1613-1. Inject sample aliquot manually using solvent flush technique or with autosampler. NOTE: If peak area is above the linear range of the working standards, dilute with CH 2Cl2, reanalyze, and apply the appropriate dilution factor in calculations. Measure peak area.

CALCULATIONS: 13.

14.

Determine the mass, mg (corrected for DE) of pyridine found in the sample front (W f) and back (W b) sorbent sections, and in the average media blank front (B f) and back (B b) sorbent sections. NOTE: If W b > W f/10, report breakthrough and possible sample loss. Calculate concentration, C, of pyridine in the air volume sampled, V (L):

EVALUATION OF METHOD: Method S161 was issued on August 1, 1975 [3], and validated with atmospheres generated by calibrated syringe pump and confirmed using a total hydrocarbon analyzer [2]. Average recovery was 109% ±3.6% (18 samples) in the range 7.6 to 30.4 mg/m 3 for 100-L samples. Breakthrough (effluent concentration = 5% of test concentration) was not observed after sampling for 240 min at 0.93 L/min from an atmosphere containing 30.4 mg/m 3 pyridine in dry air. Carbon disulfide and methanol were tested and rejected as possible desorbing solvents. Carbon disulfide gave an average DE of 0.734; methanol, 0.201. Desorption efficiency using methylene chloride for 18 spiked samples in the range 0.8 to 3.1 mg pyridine per sample averaged 0.81 with S r = 0.013.

REFERENCES: [1] Documentation of the NIOSH Validation Tests, S161, U.S. Department of Health, Education, and Welfare, Publ. (NIOSH) 77-185 (1977), available as Stock No. PB 274-248 from NTIS, Springfield, VA 22161. [2] UBTL, Inc. Report, NIOSH Sequences 4949-K (unpublished, May 24, 1985) and 3030-K (unpublished, July 20, 1981). [3] NIOSH Manual of Analytical Methods, 2nd. ed., V. 3, S161, U.S. Department of Health, Education, and Welfare, Publ. (NIOSH) 77-157-C (1977).

NIOSH Manual of Analytical Methods (NMAM), Fourth Edition, 8/15/94