Page:LA2-NSRW-2-0487.jpg

INDIAN TERRITORY traditions of an early emigration from some region either north or south. The most civilized tribes when America was discovered, were those found from New Mexico to Peru. They had buildings of which remains are still found; while the northern Indians dwelt in tents or other movable buildings. All the tribes were hunters and fishers, raising a few crops, as corn, beans and tobacco. They made pottery, stone pipes, arrowheads, snow-shoes and bark canoes and baskets. The Pueblo Indians of New Mexico built towns and temples. The Mexican and Peruvian tribes had modes of keeping records. They were governed by chiefs, who sometimes were made such by inheritance and sometimes by merit. They believed in a future life, and carefully buried their dead. In South America and Mexico the Indians have largely mingled with the conquering races, and are much less distinct from them than in the United States. The Indian wars of the United States began in Virginia in 1622 and in New England in 1637, and continued at intervals, with many victories by the Indians and terrible massacres of the whites; but in the long run with the sure defeat of the savage by the arts and arms of civilization. The Indians have been steadily pushed westward, and have been deprived of their lands by treaties, which have again and again been broken. The present policy of the United States government is to break up the reservations, do away with the tribes and make citizens of the Indians. Schools have been established, and there are 12 government training schools for Indian youth, where from 3,000 to 4,000 can be cared for. In 1907 the appropriation made by Congress for Indian schools was over $9,000,000. In 1887 Congress confirmed the Indian title to all reservations, of which there are about 133, including 116,000,000 acres. Every Indian in the United States, with the exception of the Alaska Indians and those of the five civilized tribes, could receive 160 acres apiece, and still enough land be left to pay the entire cost of educating the Indian children. The whole number of Indians in the United States, leaving out Alaska, in 1905 was 284,079. They are found in Maine, New York, North Carolina, Michigan, Minnesota, Iowa, Montana, Nebraska, Oregon, Washington, North and South Dakota, Colorado, Idaho, Arizona, Nevada, New Mexico, Utah, Wisconsin, Wyoming, California, Texas and Oklahoma. Some of the principal tribes, at present, are the Choctaws, Cherokees, Creeks, Chippewas, Chickasaws, Sioux, Illinois, Sacs, Foxes, Seminoles, Comanches, Apaches, Navajos, Pueblos, Cheyennes and Nez Percés. See A Century of Dishonor by Helen Hunt Jackson; American Indians by Catlin; Native Races of the Pacific States by Bancroft; Story of the American Indian by Brooks; and Red Race of America by Schoolcraft.  Indian Territory. See.   In′dica′tor (steam-engine), an instrument for drawing automatically a figure showing the instantaneous expansions and also the corresponding pressures of the steam in a steam-engine cylinder. The figure is called an indicator diagram. The expansion of the steam multiplied by the pressure gives the work the steam is doing. By letting vertical distances represent volumes, the area of the figure equals average pressure times change of volume or area equals work done.



The common indicator is due to Richards. It consists of a small cylinder which can be connected to the cylinder of the steam-engine. The pressure of the steam acts on the piston in the indicator cylinder and compresses a spiral spring. The amount of this compression is indicated by a pointer and measures the pressure. The pointer moves up and down with the changes of pressure, tracing a line on a paper wound on a small drum. This drum is attached to the piston-rod of the engine, so that it rotates backward and forward with the motion of the piston. But the position of the engine piston gives the volumes of the steam in the cylinder. The pointer thus traces a figure in which horizontal changes represent expansions or changes in volumes and vertical distances represent changes in pressure. The indicator diagram is used to study the performance of the valves of an engine and also to calculate the work the steam is doing. This is called indicated power as distinguished from brake-power, which is the power 