Page:Experimental researches in chemistry and.djvu/275

260 should be placed on the middle of the half next the fire, and then a piece of connecting air-tube taken, which being laid on the bottom of the chamber, may extend from the fixed air-tube by the side of the gauge as far as the middle, or even towards the further side of the chamber. After this, pieces of Cornish tile (53), or other clean earthenware which will not fly in the fire, contain but little iron, and are free from glaze, are to be prepared, of such size that they will fit in loosely round the gauge, covering the rest of that half of the chamber bottom, and serving to support the sides of the tray when in its place. This support to the tray is highly needful; for, otherwise, the weight of the glass, and the action of stirring, would be more than the thin and heated platinum could support. The thickness of the pieces should be, for the plate in question, about 1 inch, and they should be all uniform in that respect. They should never rise so high as the edge of the platinum, lest glass should accidentally pass from the tray to them, or impurities from them to the glass. An excellent guide to their thickness is, to make it similar to that of the intended plate. When they have been roughly arranged around the gauge, the latter should be withdrawn, and the tray itself introduced, the pieces being now finally adjusted about it. They should not be so arranged as to press against its sides; but the latter should be at liberty, though only so much, that upon the least tendency of the sides outwards, they hould be supported by the pieces. The assistance thus given should be directed rather to the sides than the corners, and it is better that the latter should not be in contact with these adjuncts, but be allowed to sustain themselves, for they are strong enough for the purpose, and the corners are always those places at which, from one circumstance or another, the glass is most likely to pass outwards.

58. The piece of earthenware which is fitted nearest the mouth of the air-tube should have its angle taken off or some other provision made, as by making the orifice of the tube oblique, that the passage of air may be uninterrupted; and on that side the tube itself may frequently form the support to the tray. If it does, and is glazed on the exterior, a piece of loose platina foil should be wrapped round it at the part where