Page:Experimental researches in chemistry and.djvu/265

250 the gold freely and cause perfect adhesion. In such case, a single or double piece of platinum foil loosely laid over the part, prevents loss of heat from the upper surface, and frequently causes such increased elevation of temperature as to render the soldering perfect and effectual. In the few cases where this expedient has not succeeded, I have resorted to the oxyalcohol blowpipe, using a small bladder of oxygen with a little attached jet for the purpose. This has never failed to produce an effectual heat, and 15 or 20 cubical inches of oxygen are sufficient for many operations.

34. This application of patches and soldering is only secure for small holes, i. e. such as a pin might pass through, and smaller. The patches are always to be applied on that surface of the plate which is to constitute the outside of the tray; and therefore, before the soldering begins, the two surfaces should be examined, and the most polished and perfect selected as that intended for the inside. The patches are valuable in their use far beyond what the mere application of gold to the hole would be; for the heat afterwards applied to the tray, when charged with glass, is abundantly sufficient to melt gold; in which case, if unsupported by the platinum patch, the weight of glass and the action of stirring would probably force the gold out of the hole and cause the tray to run; whereas the patch of platinum, although the gold holding it to the plate is liquid, still adheres by so strong a capillary action as to be sufficient to retain its place, and being outside is not disturbed by the motion of the stirrer. Besides, after a long application of heat, the gold and platinum combine so perfectly as to become one piece of white alloy, in fusible at the heat applied.

35. The plate is now to be folded into a tray, preparatory to which, a piece of thin board is to be provided as a gauge, which in the present instance must be 7 inches square. This laid upon the plate and held tightly down, directs the foldings of the sides, and would, if placed in the middle, leave sufficient for edges one inch and a half high all round; but as the plate should serve for use several times, it is advantageous to apply the gauge a little eccentric; for then, when used for a second and third operation, its place may be shifted, and the folds not occurring where they did before, there is less chance of holes being broken through the platinum. The folds