Page:EB1911 - Volume 16.djvu/357

Rh contains. The former method is best (though more expensive), as it removes less weight, and the light shade of colour is more permanent than that obtained by using bisulphited extracts.

After the first vatting the goods are laid up in pile to drip; meanwhile the liquor is again heated, and they are then returned for another twenty-four hours, again removed and allowed to drip for 2 to 3 days, after which they are oiled with cod oil on the grain and hung up in the sheds to dry in the dark. When they have dried to an indiarubber-like condition, they are piled and allowed to heat slightly until a greyish “bloom” rises to the surface, they are then set out and stretched in a Wilson scouring machine; using brass slickers instead of the stone ones used for scouring, “pinned” over by hand (with the three-edged instrument seen in c, fig. 4, and known as a “pin”) to remove any bloom not removed by the machine, oiled and dried. When of a damp even colour they are “rolled on” between two heavy rollers like a wringing machine, the pressure being applied from above, hung up in the dark sheds again until the uneven colour so produced has dried in, and then “rolled off” through the same machine, the pressure being applied from below. They are now dried right out, brushed on the grain to produce a slight gloss, and are finished.

As regards the finishing of harness leather, &c., the goods, after thorough dripping for a day or two, are brushed, lightly scoured, washed up in hot sumach and extract to improve the colour, and are again laid up in pile for two days; they are then given a good coat of cod oil, sent to the sheds, and dried right out. Only sufficient scouring is given to clean the goods, the object of the tanner being to leave as much weight in as possible, although all this superfluous tan has to be washed out by the currier before he can proceed.

Currying.—When the goods are dried from the sheds they are purchased by the currier. If, as is often the case, the tanner is his own currier, he does not tan the goods so heavily, or trouble about adding superfluous weight, but otherwise the after processes, the art of the currier, are the same.

Currying consists of working oil and grease into the leather to render it pliable and increase its strength. It was once thought that this was a mere physical effect produced by the oil, but such is not the case. Currying with animal oils is a second tannage in itself; the oils oxidize in the fibres and produce aldehydes, which are well-known tanning agents; and this double tannage renders the leather very strong. Then there is the lubricating effect, a very important physical action so far as the strength of the leather is concerned. Mineral oils are much used, but they do not oxidize to aldehydes, or, for the matter of that, to anything else, as they are not subject to decomposition. They, therefore, produce no second tannage, and their action is merely the physical one of lubrication, and this is only more or less temporary, as, except in the case of the heavier greases, they slowly evaporate. Where animal fats and oils are used, the longer the goods are left in contact with the grease the better and stronger will be the leather.

In the “Einbrennen” process (German for “burning in”), the hides are thoroughly scoured, and when dry are dipped into hot grease, which is then allowed to cool; when it is nearly set the goods are removed and set out. This process is not much used in Great Britain.

In hand-stuffing belting butts the goods are first thoroughly soaked in water to which has been added some soda, and then scoured and stretched by machine. They are then lightly shaved, to take off the loose flesh and thin the neck. The whole of the mechanically deposited tannin is removed by scouring, to make room for the grease, and they are then put into a sumach vat of 40° barkometer to brighten the colour, horsed up to drip, and set out. If any loading, to produce fictitious weight, is to be done, it is done now, by brushing the solution of either epsom salts, barium chloride or glucose, or a mixture, into the flesh, and laying away in pile for some days to allow of absorption, when, perhaps, another coat is given. Whether this is done or not, the goods are hung up until “tempered” (denoting a certain degree of dryness), and then treated with dubbin. This is manufactured by melting down tallow in a steam-jacketed pan, and adding cod oil, the mixture being stirred continually; when quite clear, it is cooled as rapidly as possible by running cold water through the steam pan, the stirring being continued until it has set. The tempered leather having been set out on a glass table, to which the flesh side adheres, is given a thin coat of the dubbin on the grain, turned, set out on the flesh, and given a thick coat of dubbin. Then it is hung up in a wind shed, and as the moisture dries out the grease goes in. After two or three days the goods are “set out in grease” with a brass slicker, given a coat of dubbin on the grain slightly thicker than the first coat, then flesh dubbined, a slightly thinner coat being applied than at first, and stoved at 70° F. The grease which is slicked off when “setting out in grease” is collected and sold. After hanging in the warm stove for 2 or 3 days the butts are laid away in grease for a month; they are then slicked out tight, flesh and grain, and buck tallowed. Hard tallow is first rubbed on the grain, when a slight polish is induced by rubbing with the smoothed rounded edge of a thick slab of glass; they are then hung up in the stove or stretched in frames to dry. A great deal of stuffing is now carried out by drumming the goods in hot hard fats in previously heated drums; and in modern times the tedious process of laying away in grease for a month is either left undone altogether or very considerably shortened.

In the tanning and dressing of the commoner varieties of kips and dried hides, the materials used are of a poorer quality, and the time taken for all processes is cut down, so that whereas the time taken to dress the better class of leather is from 7 to 10 months, and in a few cases more, these cheaper goods are turned out in from 3 to 5 months.

A considerable quantity of the leather which reaches England, such as East India tanned kips, Australian sides, &c., is bought up and retanned, being sold then as a much better-class leather. The first operation with such goods is to “strip” them of any grease they may contain, and part of their original tannage. This is effectually carried out by first soaking them thoroughly, laying them up to drip, and drumming for half an hour in a weak solution of soda; they are then washed by drumming in plenty of water, the water is run off and replaced by very weak sulphuric acid to neutralize any remaining soda; this is in turn run off and replaced by weak tan liquor, and the goods are so tanned by drumming for some days in a liquor of gradually increasing strength. The liquor is made up as cheaply as possible with plenty of solid quebracho and other cheap extract, which is dried in with, perhaps, glucose, epsom salts, &c. to produce weight. Sometimes a better tannage is given to goods of fair quality, in which they are, perhaps, started in the drum and finished in layers, slightly better materials being used all through, and a longer time taken to complete the tannage.

The tannage of dressing hides for bag and portmanteau work is rather different from the other varieties described, in that the goods, after having had a rather longer liming, are “bated” or “puered.”

Bating consists of placing the goods in a wheel or paddle with hen or pigeon excrement, and paddling for from a few hours to 2 or 3 days. In puering, dog manure is used, and this being rather more active, the process does not take so long. This bating or puering is carried out in warm liquors, and the actions involved are several. From a practical point of view the action is the removal of the lime and the solution of the hair sacs and a certain amount of interfibrillar substance. In this way the goods are pulled down to a soft flaccid condition, which allows of the removal of short hair, hair sacs and other filth by scudding with an unhairing knife upon the beam. The lime is partially taken into solution and partially removed mechanically during the scudding. A large quantity of hide substance, semi-soluble and soluble, is lost by being pressed out, but this matters little, as for dressing work, area, and not weight, is the main consideration. Theoretically the action is due to bacteria and bacterial products (organized ferments and enzymes), unorganized ferments or vegetable ferments like the yeast ferment, such as pancreadine, pepsin, &c. and chemicals, such as ammonium and calcium salts and phosphates, all of which are present in the manure. The evolved gases also play their part in the action.

There are several bates upon the market as substitutes for dung bate. A most popular one was the American “Tiffany” bate, made by keeping a weak glue solution warm for some hours and then introducing a piece of blue cheese to start fermentation; when fermenting, glucose was added, and the bate was then ready for work. This and all other bates have been more or less supplanted by “erodin,” discovered after years of research by Mr Wood (Nottingham) and Drs Popp and Becker (Vienna). This is an artificial bate, containing the main constituents of the dung bate. It is supplied