Page:EB1911 - Volume 09.djvu/421

Rh that if a body A is in temperature-equilibrium with B, and B with C, then A must be in equilibrium with C directly. This argument can be applied, by aid of adiabatic partitions, even when the bodies are in a field of force so that mechanical work is required to change their geometrical arrangement; it was in fact employed by Maxwell to extend from the case of a gas to that of any other system the proposition that the temperature is the same all along a vertical column in equilibrium under gravity.

It had been shown from the kinetic theory by Maxwell that in a gas-column the mean kinetic energy of the molecules is the same at all heights. If the only test of equality of temperature consisted in bringing the bodies into contact, this would be rather a proof that thermal temperature is of the same physical nature in all parts of the field of force; but temperature can also be equalized across a distance by radiation, so that this law for gases is itself already necessitated by Carnot’s general principle, and merely confirmed or verified by the special gas-theory. But without introducing into the argument the existence of radiation, the uniformity of temperature throughout all phases in equilibrium is necessitated by the doctrine of energetics alone, as otherwise, for example, the raising of a quantity of gas to the top of the gravitational column in an adiabatic enclosure together with the lowering of an equal mass to the bottom would be a source of power, capable of unlimited repetition.

Laws of Chemical Equilibrium based on Available Energy.—The complete theory of chemical and physical equilibrium in gaseous mixtures and in very dilute solutions may readily be developed in terms of available energy (cf. Phil. Trans., 1897, A, pp. 266-280), which forms perhaps the most vivid and most direct procedure. The available energy per molecule of any kind, in a mixture of perfect gases in which there are N molecules of that kind per unit volume, has been found to be a′ + R′T logbN where R′ is the universal physical constant connected with R above. This expression represents the marginal increase of available energy due to the introduction of one more molecule of that kind into the system as actually constituted. The same formula also applies, by what has already been stated, to substances in dilute solution in any given solvent. In any isolated system in a mobile state of reaction or of internal dissociation, the condition of chemical equilibrium is that the available energy at constant temperature is a minimum, therefore that it is stationary, and slight change arising from fresh reaction would not sensibly alter it. Suppose that this reaction, per molecule affected by it, is equivalent to introducing n1 molecules of type N1, n2 of type N2, &c., into the system, n1, n2, ... being the numbers of molecules of the different types that take part in the reaction, as shown by its chemical equation, reckoned positive when they appear, negative when they disappear. Then in the state of equilibrium

n1 (a′1 + R′T log b1N1) + n2 (a′2 + R′T log b2N2) + ...

must vanish. Therefore N1 n1 N2 n2 ... must be equal to K, a function of the temperature alone. This law, originally based by Guldberg and Waage on direct statistics of molecular interaction, expresses for each temperature the relation connecting the densities of the interacting substances, in dilution comparable as regards density with the perfect gaseous state, when the reaction has come to the state of mobile equilibrium.

All properties of any system, including the heat of reaction, are expressible in terms of its available energy A, equal to E &minus; T + 0T. Thus as the constitution of the system changes with the temperature, we have

where

E = H + W, H = T,

H being heat and W mechanical and chemical energy imparted to the system at constant temperature; hence

which is equivalent to

This general formula, applied differentially, expresses the heat E &minus; W absorbed by a reaction in terms of A, the change produced by it in the available energy of the system, and of W, the mechanical and electrical work done on the system during its progress.

In the problem of reaction in gaseous systems or in very dilute solution, the change of available energy per molecule of reaction has just been found to be

A = A0 + R′T log K′, where K′ = b1 n1 b2 n2 ... K;

thus, when the reaction is spontaneous without requiring external work, the heat absorbed per molecule of reaction is

This formula has been utilized by van ’t Hoff to determine, in terms of the heat of reaction, the displacement of equilibrium in various systems arising from change of temperature; for K, equal to N1 n1 N2 n2 ..., is the reaction-parameter through which alone the temperature affects the law of chemical equilibrium in dilute systems.

Interfacial Phenomena: Liquid Films.—The characteristic equation hitherto developed refers to the state of an element of mass in the interior of a homogeneous substance: it does not apply to matter in the neighbourhood of the transition between two adjacent phases. A remarkable analysis has been developed by J. W. Gibbs in which the present methods concerning matter in bulk are extended to the phenomena at such an interface, without the introduction of any molecular theory; it forms the thermodynamic completion of Gauss’s mechanical theory of capillarity, based on the early form of the principle of total energy. The validity of the fundamental doctrine of available energy, so far as regards all mechanical actions in bulk such as surface tensions, is postulated, even when applied to interfacial layers so thin as to be beyond our means of measurement; the argument from perpetual motions being available here also, as soon as we have experimentally ascertained that the said tensions are definite physical properties of the state of the interface and not merely accidental phenomena. The procedure will then consist in assuming a definite excess of energy, of entropy, and of the masses of the various components, each per unit surface, at the interface, the potential of each component being of necessity, in equilibrium, the same as it is in the adjacent masses. The interfacial transition layer thus provides in a sense a new surface-phase coexistent with those on each side of it, and having its own characteristic equation. It is only the extent of the interface and not its curvatures that need enter into this relation, because any slight influence of the latter can be eliminated from the equation by slightly displacing the position of the surface which is taken to represent the interface geometrically. By an argument similar to one given above, it is shown that one of the forms of the characteristic equation is a relation expressing the surface tension as a function of the temperature and the potentials of the various components present on the two sides of the interface; and from the differentiation of this the surface densities of the superficial distributions of these components (as above defined) can be obtained. The conditions that a specified new phase may become developed when two other given ones are brought into contact, i.e. that a chemical reaction may start at the interface, are thence formally expressed in terms of the surface tensions of the three transition layers and the pressures in the three phases. In the case of a thin soap-film, sudden extension of any part reduces the interfacial density of each component at each surface of the film, and so alters the surface tension, which requires time to recover by the very slow diffusion of dissolved material from other parts of the thin film; the system being stable, this change must be an increase of tension, and constitutes a species of elasticity in the film. Thus in a vertical film the surface tension must be greater in the higher parts, as they have to sustain the weight of the lower parts; the upper parts, in fact, stretch until the superficial densities of the components there situated are reduced to the amounts that