Page:EB1911 - Volume 08.djvu/165

 volume of 800 pages entirely to the subject. This was published in 1612, and may be considered to contain all that was known at that time.

In the 18th century clocks and watches began to supersede sun-dials, and these have gradually fallen into disuse except as an additional ornament to a garden, or in remote country districts where the old dial on the church tower still serves as an occasional check on the modern clock by its side. The art of constructing dials may now be looked upon as little more than a mathematical recreation.

General Principles.—The diurnal and the annual motions of the earth are the elementary astronomical facts on which dialling is founded. That the earth turns upon its axis uniformly from west to east in twenty-four hours, and that it is carried round the sun in one year at a nearly uniform rate, is the correct way of expressing these facts. But the effect will be precisely the same, and it will suit our purpose better, and make our explanations easier, if we adopt the ideas of the ancients, of which our senses furnish apparent confirmation, and assume the earth to be fixed. Then, the sun and stars revolve round the earth’s axis uniformly from east to west once a day—the sun lagging a little behind the stars, making its day some four minutes longer—so that at the end of the year it finds itself again in the same place, having made a complete revolution of the heavens relatively to the stars from west to east.

The fixed axis about which all these bodies revolve daily is a line through the earth’s centre; but the radius of the earth is so small, compared with the enormous distance of the sun, that, if we draw a parallel axis through any point of the earth’s surface, we may safely look on that as being the axis of the celestial motions. The error in the case of the sun would not, at its maximum, that is, at 6 and 6, exceed half a second of time, and at noon would vanish. An axis so drawn is in the plane of the meridian, and points to the pole, its elevation being equal to the latitude of the place.

The diurnal motion of the stars is strictly uniform, and so would that of the sun be if the daily retardation of about four minutes, spoken of above, were always the same. But this is constantly altering, so that the time, as measured by the sun’s motion, and also consequently as measured by a sun-dial, does not move on at a strictly uniform pace. This irregularity, which is slight, would be of little consequence in the ordinary affairs of life, but clocks and watches being mechanical measures of time could not, except by extreme complication, be made to follow this irregularity, even if desirable.

The clock is constructed to mark uniform time in such wise that the length of the clock day shall be the average of all the solar days in the year. Four times a year the clock and the sun-dial agree exactly; but the sun-dial, now going a little slower, now a little faster, will be sometimes behind, sometimes before the clock—the greatest accumulated difference being about sixteen minutes for a few days in November, but on the average much less. The four days on which the two agree are April 15, June 15, September 1 and December 24.

Clock-time is called mean time, that marked by the sun-dial is called apparent time, and the difference between them is the equation of time. It is given in most calendars and almanacs, frequently under the heading "clock slow," "clock fast." When the time by the sun-dial is known, the equation of time will at once enable us to obtain the corresponding clock-time, or vice versa.

Atmospheric refraction introduces another error by altering the apparent position of the sun; but the effect is too small to need consideration in the construction of an instrument which, with the best workmanship, does not after all admit of very great accuracy.

The general principles of dialling will now be readily understood. The problem before us is the following:—A rod, or style, as it is called, being firmly fixed in a direction parallel to the earth’s axis, we have to find how and where points or lines of reference must be traced on some fixed surface behind the style, so that when the shadow of the style falls on a certain one of these lines, we may know that at that moment it is solar noon,—that is, that the plane through the style and through the sun then coincides with the meridian; again, that when the shadow reaches the next line of reference, it is 1 o’clock by solar time, or, which comes to the same thing, that the above plane through the style and through the sun has just turned through the twenty-fourth part of a complete revolution; and so on for the subsequent hours,—the hours before noon being indicated in a similar manner. The style and the surface on which these lines are traced together constitute the dial.

The position of an intended sun-dial having been selected—whether on church tower, south front of farmstead or garden wall—the surface must be prepared, if necessary, to receive the hour-lines.

The chief, and in fact the only practical difficulty will be the accurate fixing of the style, for on its accuracy the value of the instrument depends. It must be in the meridian plane, and must make an angle with the horizon equal to the latitude of the place. The latter condition will offer no difficulty, but the exact determination of the meridian plane which passes through the point where the style is fixed to the surface is not so simple. At present we shall assume that the style has been fixed in its true position. The style itself will be usually a stout metal wire, and when we speak of the shadow cast by the style it must always be understood that the middle line of the thin band of shade is meant.

The point where the style meets the dial is called the centre of the dial. It is the centre from which all the hour-lines radiate.

The position of the XII o’clock line is the most important to determine accurately, since all the others are usually made to depend on this one. We cannot trace it correctly on the dial until the style has been itself accurately fixed in its proper place. When that is done the XII o’clock line will be found by the intersection of the dial surface with the vertical plane which contains the style; and the most simple way of drawing it on the dial will be by suspending a plummet from some point of the style whence it may hang freely, and waiting until the shadows of both style and plumb-line coincide on the dial. This single shadow will be the XII o’clock line.

In one class of dials, namely, all the vertical ones, the XII o’clock line is simply the vertical line from the centre; it can, therefore, at once be traced on the dial face by using a fine plumb-line.

The XII o’clock line being traced, the easiest and most accurate method of tracing the other hour-lines would, at the present day when good watches are common, be by marking where the shadow of the style falls when 1, 2, 3, &c., hours have elapsed since noon, and the next morning by the same means the forenoon hour-lines could be traced; and in the same manner the hours might be subdivided into halves and quarters, or even into minutes.

But formerly, when watches did not exist, the tracing of the I, II, III, &c., o’clock lines was done by calculating the angle which each of these lines would make with the XII o’clock line. Now, except in the simple cases of a horizontal dial or of a vertical dial facing a cardinal point, this would require long and intricate calculations, or elaborate geometrical constructions, implying considerable mathematical knowledge, but also introducing increased chances of error. The chief source of error would lie in the uncertainty of the data; for the position of the dial-plane would have to be found before the calculations began,—that is, it would be necessary to know exactly by how many degrees it declined from the south towards the east or west, and by how many degrees it inclined from the vertical. The ancients, with the means at their disposal, could obtain these results only very roughly.

Dials received different names according to their position:—

Horizontal dials, when traced on a horizontal plane;

Vertical dials, when on a vertical plane facing one of the cardinal points;

Vertical declining dials, on a vertical plane not facing a cardinal point;

Inclining dials, when traced on planes neither vertical nor horizontal (these were further distinguished as reclining when leaning backwards from an observer, proclining when leaning forwards);

Equinoctial dials, when the plane is at right angles to the earth’s axis, &c. &c.

Dial Construction.—A very correct view of the problem of dial construction may be obtained as follows:—



Conceive a transparent cylinder (fig. 1) having an axis AB parallel to the axis of the earth. On the surface of the cylinder let equidistant generating-lines be traced 15° apart, one of them XII XII being in the meridian plane through AB, and the others I  I, II  II, &c., following in the order of the sun’s motion.

Then the shadow of the line AB will obviously fall on the line XII XII at apparent noon, on the line I  I at one hour after noon, on II  II at two hours after noon, and so on. If now the cylinder be cut by any plane MN representing the plane on which the dial is to be traced, the shadow of AB will be intercepted by this plane and fall on the lines AXII AI, AII, &c.

The construction of the dial consists in determining the angles made