Page:Current Strategies for Engineering Controls in Nanomaterial Production and Downstream Handling Processes.pdf/54

 A ventilated, collar-type hood around the discharge point can help minimize worker exposure to dust. Figure 14 presents a control approach for filling bags with solid powder materials [HSE 2003c]. The control includes the specification of a ventilated enclosure around the powder discharge outlet and applies to filling smaller product bags as well as intermediate bulk containers. This design guidance recommends an inward air velocity of 200 ft/min (1.0 m/s) into the enclosure. The ACGIH Industrial Ventilation Manual [ACGIH 2013], Design plate VS-15-02, Bag Filling, is similar in design to the HSE exhaust hood (Figure 14) but specifies an overall hood flow rate of 400–500 ft3/min for nontoxic dust or 1,000–1,500 ft3/ min for toxic dust with a maximum inward air velocity of 500 ft/min. These flow rates have been specified for common industrial powders and may need to be adjusted based on the process and properties of the nanoscale materials being addressed to prevent excessive loss of product.



Figure 14. Ventilated collar-type exhaust hoods for containing dust during product discharge or manual bag filling (Contains public sector information published by the Health and Safety Executive and licensed under the Open Government License v1.0.) Current Strategies for Engineering Controls in Nanomaterial Production and Downstream Handling Processes

39