Page:30 CFR 1993.pdf/32

Mine Safety and Health Admin., Labor ==== § 7.63 Application Requirements. ==== (a) Each application for approval of a blasting unit shall include the following:

(1) An overall assembly drawing showing the physical construction of the blasting unit.

(2) A schematic diagram of the electric circuit.

(3) A parts list specifying each electric component and its electrical ratings, including tolerances.

(4) A layout drawing showing the location of each component and wiring.

(5) The model number or other manufacturer’s designation of the blasting unit.

(b) All drawings shall be titled, numbered, dated, and Include the latest revision number. The drawings may be combined into one or more composite drawings.

(c) The application shall contain a list of all the drawings submitted, including drawing titles, numbers, and revisions.

(d) A detailed technical description of the operation and use of the blasting unit shall be submitted with the application.

(Approved by the Office of Management and Budget under control number 1219-0100)

§ 7.64 Technical requirements.
(a) Energy output. Blasting units shall meet the acceptable performance criteria of the output energy test in § 7.66.

(b) Maximum blasting circuit resistance. The maximum value of the resistance of the blasting circuit that can be connected to the firing line terminals of the blasting unit, without exceeding its capacity, shall be specified by the applicant. The specified maximum blasting circuit resistance shall be at least 150 ohms.

(c) Visual indicator. The blasting unit shall provide a visual indication to the user prior to the operation of the firing switch when the voltage necessary to produce the required firing current is attained.

(d) Firing switch. The switch used to initiate the application of energy to the blasting circuit shall—

(1) Require deliberate action for fits operation to prevent accidental firing:

(2) Operate only when the voltage necessary to produce the required firing current is available to the blasting circuit.

(e) Firing tine terminals. The terminals used to connect the blasting circuit to the blasting unit shall—

(1) Provide a secure, low-resistance connection to the blasting circuit as demonstrated by the firing line terminals test in § 7.68;

(2) Be corrosion-resistant;

(3) Be Insulated to protect the user from electrical shock; and

(4) Be separated from each other by an insulated barrier.

(f) Ratings of electric components. No electric component of the blasting unit, other than batteries, shall be operated at more than 90 percent of any of its electrical ratings in the normal operation of the blasting unit.

(g) Non-incendive electric contacts. In the normal operation of a blasting unit, the electric energy discharged by making and breaking electric contacts shall not be capable of igniting a methane-air atmosphere, as determined by the following:

(1) The electric current through an electric contact shall not be greater than that determined from Figure D-1.

(2) The maximum voltage that can be applied across an electric contact that discharges a capacitor shall not be greater than that determined from Figure D-2.

(3) The electric current through an electric contact that interrupts a circuit containing inductive components shall not be greater than that determined from Figure D-3, Inductive components include inductors, chokes, relay coils, motors, transformers, and similar electric components that have an inductance greater than 100 microhenries. No inductive component in a circuit with making and breaking electric contacts shall have an inductance value greater than 100 millihenries. Rh